Top selling boiler economizer ecnomiser bare tube type heat recovery devices
Types of Economiser in Boiler
1. Boiler Economisers can be classified in various ways depending upon economizer’s function and operation.
2. An economizer can be made pressurized or non-pressurized depending on the required water temperature through it.
3. Thermodyne manufactures both Pressurized Economisers as well as non-pressurized Economisers to suit your needs.
4. Generally, If the required water temperature is above the normal boiling point at atmospheric pressure, then the Boiler Economisers are needed to be pressurized and if they are below the boiling point they can be made non-pressurized.
5. Thermodyne boilers has a lot of experience in manufacturing Economisers and is tailor-made in order to suit your specific requirements.
6. The compact designs Thermodyne Boiler Economiser further reduce the flue gas losses and will save you a good fortune in terms of the fuel usage thereby lowering the operating cost.
The function of Boiler Economiser
1. The Economizer in Boiler works on the principle of Heat Transfer. Heat transfer usually takes place from high temperature to low temperature.
In the case of Boilers, flue gases or exhaust from the boiler outlet are at high temperature and water that needs to be preheated is at low temperature.
2. So, this temperature difference between water and flue gases helps to increase the feed water temperature.
3. Depending on the type of operations, design of Economisers can be smoke tube type or water tube type.
4. In smoke tube type flue gases are inside the tubes and water is on the shell side while in the water tube type, water is in the tube and flue gases are on the shell side.
Boiler Economiser and Waste Heat Recovery Concept
1. Boilers are generally designed to produce steam from water. Water is converted to steam by transferring both sensible and latent heat.
2. Sensible heat is the amount of heat required to increase the temperature of water at constant pressure without changing its liquid state, while Latent heat is the amount of heat required to change the state from Liquid to Vapor at constant temperature and pressure.
3. The exhaust from the boilers is generally in the temperature range of 200°C – 250°C, so there are a huge amount of losses from the boiler if any heat recovery devices are not installed after it.
4. If the exhaust gases which are leaving the Boiler at such high temperature is made to pass through the Economiser in order to provide the required sensible heat to the water by increasing its temperature, it will reduce the heat load on the boiler to the greater extent.
Specification
| Description | Boiler economizer |
| Material | Alloy steel, Carbon steel, SA210C ,SA213T22, etc |
| Material standard | ASTM, EN or ISO etc. |
| Dimension | Customization |
| Weight | Min: 10 ton
Max.:1000 ton |
| Smelting Process: | EF+LF + VD |
| Process | Material→Ingot → Hot/Cold-Rolling→ Heat treatment (Normalizing+ tempering) → Inspection →rough machining→UT →2nd Heat treatment →finishing machining →Inspection |
| UT standard | ASTM A388 or EN10228, etc |
After Painting
Product Tags:
|
|
Heat Recovery Economiser Coil , Steam Boiler Economizer Bare Tube Type Images
|
